The electrochemical behavior of Te in alkaline media was determined by cyclic voltammetry and linear sweep voltammetry measurements. It indicated that TeO32− ion was first reduced to Te(s), then to Te22− ion. For the first time, the pulsed electrodeposition of tellurium on stainless steel has been studied in an alkaline bath and the effect of duty cycle, frequency, and current density on current efficiencies and morphology were indicated at room temperature. Pulse duty cycles ranging from 10 to 75%, frequencies ranging from 10 to 100 Hz, and current densities ranging from 7.5 to 30 mA/cm2 were employed. The morphology of the electrodeposition of tellurium samples was characterized by SEM. The results showed that due to increasing side reactions at higher current density, the current efficiency decreased with increasing current density. The results of Scanning Electron Microscopy (SEM) cleared that more compact structures with lower porosity were observed for the electrodeposits at lower current densities and less compact samples were obtained at higher current densities. It has been found that the current efficiency of tellurium plating decreases as the pulse duty cycle increases from 10% to 75%. Maximum current efficiency has been observed at 10% duty cycle. The study of the effect of duty cycle on morphology showed that the samples synthesized at a duty cycle of 10% and 25% have approximately similar appearance and particle size. With more increasing of duty cycles to 50 and 75% due to increasing hydrogen evolution rate and H2 bubbling at the electrode surface the morphology has been changed remarkably. The current efficiency of the deposit tellurium exhibited a strong dependence on the frequency. As frequency increases, the current efficiency almost decreases. In most cases, the maximum current efficiency is obtained at a 10 Hz frequency. The study of the effect of frequency on morphology showed that hydrogen evolution plays a significant role in the morphology formation of samples obtained at low pulse frequency (10 Hz), two processes of hydrogen evolution and anisotropic growth have key roles in morphology formation at medium pulse frequency (50 Hz) and anisotropic growth is the mechanism of morphology formation at high pulse frequency (100 Hz).
